Iei 232se keypad programming series#

The proximity reader is capable of being mounted up to a maximum of 10 feet away from the prox.pad. Simple programming allows the output to toggle (by code) or time from 1 to 90 seconds. The prox.pad can be used for stand alone access control, or used as a reader for IEI access systems or most Wiegand systems. The lock release relay shall be rated at 8 amps and shall be tough enough to handle any locking device. This output may be wired to a siren, buzzer, guard station, camera or any other device. IEI does not assume any responsibility for damage or injury to person or property due to improper care, storage, handling, abuse, misuse, normal wear and tear, or an act of God.

Iei 232se keypad programming series#

The system shall alert the resident to any 'propped' door by energizing a 1 amp Form 'C' relay. Iei keypad amazon flush indoor mount sc st linear user llc door walmartIei-2000e iei indoor/outdoor keypad Keypad iei reprogramIei-232fx iei design series xtreme flush mount keypad. 262 The Partitioner- Self-contained 2-zone control. For more information, Connect With Us and let IDN help find what you need. 240 Battery Operated Keypad- Direct keyswitch replacement (for indoor use). The systems propped door relay can be programmed for a 1 to 15 minute time window in which the door may be held open after a valid entry. The sealed environment 232SE style keypad features a brushed metal housing that has been treated to resist corrosion and an all metal Braille, alpha-numeric. OTHER DOOR-GARD PRODUCTS FROM IEI CONTROL PANEL INTERFACE SERIES 210 Programmable Keypad- Direct hardwire keyswitch replacement. This output can be programmed to energize for up to 15 minutes or latch. Codes may be from 1-6 digits in length and digits may be repeated.Īssisted by the door position sensor input, this 1 amp Form-C relay shall energize if the door is opened without a valid user entry or egress input. The keypad memory shall have nonvolatile EEPROM memory for up to 64 users and is upgradable to 120.

Remove the antenna housing from the keypad/controller by pressing the labeled four secure tabs inward (see Figure 5) until the antenna housing pops out. Do not pull this ribbon cable out of its connector Once the main board is removed, you can access the interior of the antenna.

The access control system shall be Alpha Communications® / IEI model 232SE keypad or approved equivalent. now holds the main board to the keypad board.